Noodle packaging machine failure how to deal with?

The noodle packaging machine combines mechanical, pneumatic and electronic technologies into one, with the advantages of strong stability, easy operation, low energy consumption and environmental protection.

Today, Xiao Bian analyzes the common faults and processing methods of noodle packaging machines for everyone to better understand and use the product.

Xiao Bian summed up a total of seven questions for everyone on the noodle packaging machine, involving paper, glue, paper, landing position, packaging, cross-section, coating these aspects.

1. Absorb no paper, do not absorb paper, absorb two sheets of paper, or blow paper

The causes of this failure are numerous, and the possible causes are: the distance between the paper and the paper teeth is too far; the distance from the paper sucker to the paper is too far; the motor steering error occurs during wiring; the air pipe is broken; the deflation handle is not closed . Need to adjust the equipment according to the actual situation.

2. No glue, less glue or glue

Check if there is foreign matter under the nozzle or if the inner single-valve valve inner ring is damaged.

3. The paper is too high or too low

The paper is too high or too low because the paper lifter does not adjust the position of the paper rocker arm. The paper lifter needs to be adjusted to a suitable position and the limit bolt at the front end of the paper rocker arm is fastened. .

4. Inaccurate landing position

The reason for the inaccurate landing position is that the position of the chain plate is forward or backward. It is necessary to loosen the tension bolt at the rear end to find the correct landing position.

5. Packed too loose

First, select high-quality glue and paper. If problems occur during use, check whether the pin hole of the nozzle is blocked. If the nozzle hole is blocked, you need to clear the nozzle hole.

6. There are more sections or sections

The reason for this result is that the gap between the front and back of the packaging machine is more than 1mm or the upper dead point of the kneading tank is too high. Adjust the clearance or adjust the clearance to about 35mm from the upper plane of the rear clamp after adjusting the clearance.

7. There is oil in the glue when gluing

The main reason is that the diaphragm in the rubber pump is broken, the diaphragm is replaced, and the clean rubber pump can be solved.

In daily use, in order to reduce the frequency of failure of the noodle packaging machine, the maintenance of the packaging machine is also essential. Xiaobian has several recommendations for using the noodle packaging machine for everyone:

1. Be careful not to put any items on the device;

2. Clean the equipment every day after work and do dust protection work;

3. Perform inspection and maintenance once a month. Tighten the chain, bolts and other devices on the equipment. If components on the equipment are worn, they need to be replaced in time. The transmission and rotating parts need to be kept clean and coated with calcium grease.

4. Open the air pump cover regularly for cleaning.