Grinder maintenance of the four points to note
At present, many companies in the purchase of machine tools, the main concern is the performance and price of the machine, but for the follow-up maintenance of the machine but not too much care. In fact, we can think from the car around us. When we are buying a car, because of the safety of our life, we will keep it in good time when it comes to car maintenance. For machine tools, to create benefits for the enterprise to the maintenance cycle but the lack of necessary maintenance, so it is prone to failure, reduce the service life of the machine. Part of the grinder operator grindstone maintenance are perfunctory, so often grinding machine failure, affecting work efficiency. Xiao Bian finishing maintenance on this grinder some suggestions. First, the machine installation The bearing capacity of the factory floor and the machine running area, such as the ground bearing is not enough, will affect the machine tool benchmark run away. Grinder hydraulic oil and lubricant oil choice, and must use new oil. Shaft oil briefly use 32 # or 46 # anti-wear hydraulic oil, lubricating rail oil with 46 # rail oil, pay attention to the type of grinding machine, prepare enough oil. Power cord matching, such as the wire will be too hot wire, overloaded, resulting in short circuit tripping, affecting the factory power production; machine unloading in place, you must ensure that the unloading equipment enough bearing capacity, the aisle enough for machine movement The space, will not cause the collision of the machine tool and the personnel safety. Second, the machine before processing Grinding machine installed in place to check the tubing, wires, plumbing joints are locked. Grinding machine transmission parts in power on, please use manual test machine to ensure that the various parts of the drive has been opened. The operator also needs to be aware of the spindle's orientation of the grinding machine, the matching of the grinding wheel with the machining material, and the balance of the grinding wheel. Third, machine grinding Check whether the workpiece adsorption or clamping firm, the distance between the wheel and the workpiece. On the transmission parts of the operating speed and feed processing observation, to prevent accidental findings. After turning the workpiece or after the shift grinding, to the disk and the workpiece adsorption surface to clean, close to the use of air pressure gun clean-up. Boot sequence Magnetic disk suction, hydraulic, grinding wheel, open the valve, pump, shutdown sequence is to open the valve, pump, hydraulic, spindle, disk demagnetization. Fourth, routine maintenance of machine tools Operators before get off work on the grinding table and the surrounding garbage disposal, observe the grinder to see if there is leakage around. Weekly check the grinder rail lubrication. Every 15-20 days to clean the grinder cooling water tank, every 3 to 6 months to replace the machine guide rail lubricant, replace the guide rail, please clean the oil pool and the pump filter, every 1 year to replace the hydraulic oil, fuel tank and filter Net cleaning. Grinder idle for more than 2-3 days above do not have to clean up the work surface dry anti-rust oil to prevent rusting countertops. headphones display stand, acrylic headphone display, headphone display rack, acrylic headphone display stand, earphone display stand, acrylic earphone display stand Shenzhen Apex Artcrafts Co,.LTD , https://www.apexdisplaycn.com