Water truck safety technology
First, water absorption A. The sprinkler should be as close as possible to the operating point and parked. Second, spraying operations
HAE wall printer height can customize between 2M to 3M, standard machine width is 3M, customer could order extra lead rail or do photo joint, so the printing width is limitless, and printing resolution up to 1440dpi
We developed new direct to wall inkjet printer with it own PC, and operated on tablet, the mural printing machine any print any format photo in any size on canvas, wood, wall, wall paper, tile, glass etc. directly
Direct To Wall Inkjet Printer, Zeescape Wall Printer,Inkjet Printer On Wall, Vertical Wall Decor Printer,Wall Paper Printer, Wall Inkjet Printer, 3D Wall Printer, Wall Printer Machine, Vertical Wall Printer Wuhan HAE Technology Co., Ltd. , https://www.whwallprinter.com
B. Open the side door of the platform box and take out the water-absorbing rubber hose so that it swings back without bending.
C. Pull the water suction hose into the water as deep as possible to ensure that the pipe end is always 300mm below the liquid level during the operation.
D, push the four-way valve handle to vertical to the ground.
E. Hitch the transmission to neutral, then start the engine, disengage the clutch, pull the power take-off switch backwards to pull the file, and the pump starts to run.
F, the observer can pass through the observation lens on the upper part of the rear head. When the liquid level reaches the middle of the observation mirror, the driver should be informed. Colleagues should quickly pull the water suction hose off the water or close the four-way valve.
G. After retracting the hose, place it back in the walk-in box and close the side door.
H. Move the water truck away from the pumping site.
A, Pull the rear handle of the four-way valve to parallel with the ground, open the ball valve you want to spray (front punch, back spray, side spray, shower), then start the engine, put the transmission into the gear, and turn the power take off switch. Pull backwards to pull on the file, then disengage the clutch and the pump starts to run.
B. After the water in the tank is sprinkled, the driver should push the power take-off handle forward to remove the gear and the sprinkler should stop running. 